Airbrush Compressor Pressure Regulator Water Trap Filter Water Moisture Gauge AFR-2000

Item Description

Advanced Mini Regulator with Gauge & Water Trap Filter

Improve your Airbrushes Performance by using this Regulator for Accurate, Moisture-Free Airflow!

Feature:

Precise Control of Air Flow and Pressure:

Pressure regulator with a 100psi gauge

Water Trap Filter:

Ensures clean, moisture free dry air and equiped with an easy release moisture drain

Easy to Use:

Pull the top button up; turn clockwise to increase the pressure; turn counter-clockwise to release the pressure

Fittings: 2X 1/8"-1/4"BSP fitting adatper

Package Includes:

1x Regulator with Gauge & Water Trap Filter

2X 1/8"-1/4"BSP FITTING

1X Wall Mount Bracket

FAQ

1.Question: Water trap doesn't hold air anymore, what gives?

Answer: Not exactly sure what you mean by “doesn’t hold air” so I will assume you mean that the bowl leaks air whenever air pressure is applied to the inlet. The unit I have purchased has worked flawlessly but previous units I have used have occasionally developed leaks. In general there could be four reasons fir this. [1] The plastic bowl could be broken & would need to be replaced. [2] the bowl is loose & needs to be hand tightened by gripping it with your fingers & turning it clockwise into the base. [3] The bowl O-ring is missing, damaged or out of position. Unscrew the bowl & remove it from the base. An O-ring should come out with it. Make sure it is not cut or damaged. Carefully place it on the rim of the bowl & replace the bowl & ring together in the base. A tiny dab of Vaseline on the O.ring will help it seat properly. Finally [4], dirt can get into the seat of the spring loaded drain valve on the bottom of the bowl. Push the pin a few times with the valve with full air pressure applied to clear any dirt that might be keeping the valve from seating. Hope this helps.

2.Question: What is the maximum inlet pressure?

Answer: I found that the best psi is between 30 to 35 psi and that’s for me. It may range depending on what your doing and type of airbrush. But you do not want to exceed over 45 psi

3.Question: The answers for maximum inlet side pressure is unclear. i have a 200 psi compressor, will this regulate safely reduce 200 psi to 20-40 psi?

Answer: 200 psi geez that's a lot. You might run a bigger more heavy duty reg first down to 60-70 psi if your compressor doesnt have one on it. Its kinda how i have my setup for airbrushing. This one is bolted to my table next to me.

Hot Tags: compressor pressure regulator water trap filter（afr-2000）, China, suppliers, manufacturers, factory