Aluminium 90 Degree Single Handle Corner Clamp Right Angle Clamp Woodworking Vice for Engineering, Welding, Carpenter, Photo Framing FP-6218

1.Material : Aluminum Alloy

2.Maximum Clamping Range:2.7 inches/7.0cm

3.Jaw Width: 2.36 inches/6cm

4.Jaw Depth: 1.4 inches/3.5cm.

5.Single- handle,Pendulum jaw, Rotating adjustable jaws

6.Weight about : 920g.

Packing Included:

1 x Corner Clamp

1.Brand New & High Quality

2.Made of Aluminum Alloy, and allows two wood block of different thicknesses to be joined to 90°.

3.Independently adjustable jaws.Clamp's body part is aluminum alloy die-casting construction, more durable and stronger but lighter to hold in hand.

4.Single handle, adjustable jaw, solid anti-skid strong rubber handle, help to sets up instantly, secures quickly.

5.Useful for woodworking, engineering and welding. Slots in base plate so you can fix the vice to a work bench or machine table.

FAQ

1.Question:

Can this product be bent to fit curved nosurfaces after it is moulded in a silicone mold?

Answer:

Yes, the material is very playable and would comply with a silicone mold. If your plan is to place a ball into a mold and press the material into shape of the mold and allow for excess material to flow through a gate that would work.

However if your plan to to place small amounts of material at incremental times it might be a challenge since the material was designed to adhere to wood not silicone.

In some cases I have used 0.02" aluminum sheet as a form and pressed the material into a void with the aluminum used as a material stop.

Once the material has dried I have separated the aluminum from the material.

For texture after the material has stated to set have pressed a rough sawn wood sample into the material to leave a texture,

In "some" cases once you pull even amounts of Part's A and B and mix the material is sometimes sticky.

The "stickiness" can be decreased prior to application if you allow it to air dry "temperature dependent" for a few 5-10 minutes - again "temperature dependent" (higher the ambient temperature the faster the material sets).

So yes the material can be molded using a silicone mold.

2.Question:

Can i use this product to fix wood siding? the wood siding on our house has cracks and I would like to fill the cracks with this product.

Answer:

I found that it was the BEST product to fill in areas on my siding. I tried Bondo but it is so sticky and set up too quickly. This stuff is my favorite. I picked out small areas of dry rot then applied wood hardener. I came back later and used this SculpWood and it worked perfectly. It dries hard as rock. I am about to have my house painted, the contractor was impressed by my efforts (I am a 65 yr. old female with no experience)....He said that he will place some sealant over it to make sure that it does not show cracks later on.

Hot Tags: aluminium 90 degree single corner clamp(fp-6218), China, suppliers, manufacturers, factory